Thread: The proper use of a Circle Hook
-
09-22-2015, 06:00 AM #1
The proper use of a Circle Hook
Just sharing, I got this from my friends in NJ Surf... no more irritating "jack em up" shouting needed here.. let me know your input and Thanks btw!
The following has been reprinted from our friends at the Jersey Coast Anglers Association JCAA - Jersey Coast Angler's Association Home Page
"The most effective way to hook a fish with a circle hook is not to raise the rod in a quick motion, more or less to reel and lift at the same time. If you do the typical hook set, you will pull the hook out of the fish’s mouth. The fish grabs the baited hook and starts to swim away. The line tightens slowly and usually pulls the hook out of the throat and to the corner of the mouth, where the point rotates and pierces the jaw hinge or check. Once the fish is hooked, it cannot escape. According to manufacturers, advantages of the circle hook design include: increased catch rate, higher lip hook rate, which greatly reduces mortality; ease of use because the fish hooks itself; and less snagging in certain bottom fishing applications. Remember, avoid the typical hook setting practice.
There has been a lot of study on the use of circle hooks so let me fill you in on some of the results. The Lukakovic test listed 97% hooked in the jaw with 1% mortality. J-hooks resulted in an 83% mouth hooking and a mortality of 9%. A study done by Caruso showed the same 97% jaw hooked and a mortality of 3% with circle style hooks, compared to only 60% jaw hooked and a mortality of 16% with J-hooks. Both these tests were conducted on Striped Bass. Does this mean that a conservative 10% mortality with J-hooks affects even the catch and release fisherman? You be the judge. Those are the numbers. Studies done on Pelagic species are even more dramatic with C-hooks 94% mouth hooked to only 62% for J-hooks. And the mortality is 4% vs. a frightening 28%."
-
09-22-2015, 06:56 AM #2
- Join Date
- Oct 2011
- Posts
- 64
- Thanks
- 66
- Thanked 33 Times in 16 Posts
Dittos. Circle hooks work.
-
09-22-2015, 07:20 AM #3
- Join Date
- Sep 2014
- Location
- Tennessee
- Posts
- 365
- Thanks
- 60
- Thanked 125 Times in 82 Posts
I have not been a circle hook user. However, for my up coming trip in October I am going to use circle hooks only. Have not packed any J hooks and don't plan on buying any. They say you can't teach an old dog new tricks but I think that if forced to use the circles only, I will get the hang of it. From what I understand you just pick up the rod, point it at the fish and start reeling. That shouldn't be to hard for even this old man to learn. We shall see.
Dance naked my friends, life is short.
-
09-22-2015, 08:51 AM #4
- Join Date
- May 2015
- Location
- Perdido Key
- Posts
- 258
- Thanks
- 617
- Thanked 347 Times in 101 Posts
'Veteran' whether active duty, discharged, retired, or reserve is someone who, at one point in his/her life, wrote a blank check made payable to 'USA' for an amount of 'up to, and including his life.'
-
The Following User Says Thank You to perdidohunter For This Useful Post:
-
09-22-2015, 09:22 AM #5
Circle hooks are undoubtedlly good , but I can not remember a fish that I have caught on the pier swallowing a treble hook . Being #4 or #10 . Why is that ? Just curious .
-
09-22-2015, 09:53 AM #6
- Join Date
- Apr 2015
- Location
- gulf shores
- Posts
- 120
- Thanks
- 107
- Thanked 118 Times in 53 Posts
Back in the mid 90's we did a study with speckled trout. All kinds of variables...live bait, JHook (my favorite!), trebles, grubs, treble hook hard baits, handling with towel, dropping on the ground (bottom of boat) etc. Survival at 30 days post release was the measuring stick. We did not use circle hooks or Kahle hooks.
Results were that about 10 percent more died from treble hooks from all sources of hooking, probably from the length of time it took to unhook them...and live bait mirrored the data. Most fish that were acvtually observed to have died were from secondary bacterial infections "vibrio" (i.e. rough handling, dropping on the ground, with a towel, etc)
NOW...OTHER CONSIDERATIONS!!! An experienced fisherman or a guide is going to get a hook out much, much faster than an average or below average fisherman. He is also "usually" going to grab the fish with his bare hand thus removing less slime therefore causing less damage for bacteria to infest the fish. Any speckled trout released after being handled with a towel are history, you just don't get to witness it. When I saw the ADSFR have the catch and release category and jackpot (I think) for speckled trout I just cringed knowing that it was a great publicity stunt but terrible idea. Trout don't release very well after being in a livewell for any length of time let alone hours.
More than 2 cents...I think that is about a nickels worth.
I can go on and on BUT the most critical factors in fish release and subsequent survival are handling and time out of the water. If they are gullet or gill hooked, cook em.
-
The Following 5 Users Say Thank You to JayHook For This Useful Post:
-
09-25-2015, 08:18 PM #7
- Join Date
- Mar 2014
- Location
- marion junction, al
- Posts
- 31
- Thanks
- 0
- Thanked 5 Times in 4 Posts
do circle hooks work as well on toothy critters like kings
-
09-25-2015, 10:11 PM #8
- Join Date
- Oct 2011
- Posts
- 221
- Thanks
- 1
- Thanked 107 Times in 58 Posts
yes, Ive seen a lot of folks even troll for kings using circles for the lead hook
-
09-25-2015, 11:40 PM #9
- Join Date
- Dec 2014
- Posts
- 33
- Thanks
- 12
- Thanked 1 Time in 1 Post
Not sure about kings bit they work great with sharks with live and cut bait.6/0 for live bait and 16/0 for cut. Better file the barbs off if you want your hook back though.
-
09-26-2015, 10:56 AM #10
- Join Date
- Feb 2014
- Location
- Foley, AL
- Posts
- 2,335
- Thanks
- 2,719
- Thanked 7,719 Times in 1,145 Posts
I started using circle hooks for whiting, reds, croakers, sheepshead, etc years ago. It's what I use for fall fishing from the pier now. It took me just a few times, on my very first day of trying them, to get the hang of it.
Well, after several hours making phone calls, I was able to track down a certain manufacturer’s service center in California. Thankfully, they agreed to send out my needed parts. These were left over...
You would think I would know this!