Thread: Bushing for pier cart wheels

I need 4 of these for the wheels on a CPI Designs Reels on Wheels Sr. Cart. They are worn to the point that they are wobbling. I can't find them on their website or get anyone to answer the phone. GCIS doesn't have them. Anyone have 4 laying around in their tackle box? The inside is for a 5/8" shaft and the outside is approximately 1-3/8".

What are the overall dimensions. What material

I.d. needs to fit over 5/8" aluminum shaft. o.d. is 1 3/8". It is about 1" thick. It has a thin "lip" where the outside meets the hub. I think the material is nylon.

well... i made mine.... took some soft pine 2x4 and used my MAD redneck skilz. a drill press, and a band saw then proceeded to the grind wheel for touch ups. 2 years and its going good.

I have found some online that fit a lawn mower tire. I may order them and hope they fit. I use the cat a little in the surf as well. It is a beast to pull over sand until you get to the wet sand. The pine may not like saltwater!

Originally Posted by chillinfish

The pine may not like saltwater!

You're probably correct, mine only see's the edge of the local lakes/ponds and then the pier. i've never actually had it down on the beach.

are you going to be down this weekend?

Originally Posted by Mr. Cleland

You're probably correct, mine only see's the edge of the local lakes/ponds and then the pier. i've never actually had it down on the beach.

are you going to be down this weekend?

Not going to be there for another few weeks.

Found them......I hope


BUSHING FLANGED WHEEL 5/8 X 1-3/8 MURRAY 56105 9044

Let me know

i put bearings in mine got them from tractor supply ,had to get a stop and a few washers for each side to lock them in